function control switch

英 [ˈfʌŋkʃn kənˈtrəʊl swɪtʃ] 美 [ˈfʌŋkʃn kənˈtroʊl swɪtʃ]

网络  功能控制开关

计算机



双语例句

  1. Function and use method and the "dual wire compatible with intelligent switch" completely consistent, and in a control network can and "dual wire compatible with intelligent switch" in practice.
    功能和使用方法与“单双线制兼容智能开关”完全一致,且在一个控制网络中可以和“单双线制兼容智能开关”混用。
  2. The main function modules and design of photoelectric control switch system based on the infrared electronic transducer technology are introduced in detail.
    详细介绍基于红外传感技术的光电控制开关系统的主要功能模块及设计。
  3. Selecting one of the function modes is done from the control panel of local cabinet ( near the furnace and the loading area) by a selecting switch.
    用选择开关从本地控制柜(和装载区域附近)控制面板上选择其中一个功能模式。
  4. Based on the building of the simulation model of unit and DEH, this paper analyzes the structure and function of DEH. And the control arithmetic of feedback loop switch and valve control mode switch is optimized by adjusting the regulator parameters of load control system.
    在建立机组及DEH系统仿真模型的基础上,分析了DEH系统的基本结构和功能,整定了负荷串级控制系统的调节器参数,优化了反馈回路投切与阀门控制方式切换的控制算法。
  5. Its main function is converting test signals, data signals and engraved signals into digital signals according to the request of the servo control, and switch digital drive signals to analog drive signals for drive board.
    主要功能是实现检测信号、数据信号和刻录信号等模拟信号转换成伺服控制器需要的数字信号,并将数字驱动信号转换成驱动板所需要的模拟驱动信号等功能。
  6. The network control unit can control interior modules function, such as power control, switch control and alarm disposal.
    网络管理单元对系统内部各功能模块进行监控管理,如功率监视/控制,开关控制,报警处理等;
  7. The switch state and control function of Matrix Convetter based on two-voltage control technique is researched, Source key is presented, and the control table of switch state is given.
    讨论了基于双电压控制的矩阵变换器的开关状态及控制函数,提出了原点开关概念和开关状态控制函数表。
  8. The basic architecture of optical burst switching network core switch node is briefly presented in this paper. The function of switch control module and the structure of core switch node are introduced in brief.
    分析了光突发交换网络核心交换节点的基本交换结构、交换控制模块的主要功能以及核心交换模块的构成;
  9. Considering the characteristics of main circuit structure and SSSC function, we present a method to control cascaded inverter by DSP+ FPGA aiming at not supplying enough PWM pulses of ordinary controlling chip because there are many switch components in multi-level inverter.
    考虑到级联逆变器的结构特点和SSSC的功能特点,针对多电平变流器开关器件多,常规的控制芯片无法提供足够的PWM脉冲,提出了一种DSP+FPGA共同控制级联型逆变器的方法。